DGSI EZ-DAQ Manual do Utilizador descarregar pdf (Página 4)

EZ-DAQ™

INTRODUCTION

Operator’s Manual EZ-DAQ™ version 1.4 4 of 25

INTRODUCTION

1.0 Overview

The EZ-DAQ is a USB-Ethernet data acquisition system used in conjunction with

EZ-DAQ-Soft software. The software is formulated for communication with only the

EZ-DAQ data acquisition system for recording readings and storing them in user

defined directories.

EZ-DAQ has provisions for 8 sensor inputs. It gives the user the convenience of digital

indicators at the test stand with the ability of transferring test data to the EZ-DAQ-Soft

software via standard Ethernet protocol. The EZ-DAQ can enable 1-to-8 industry-

standard analog sensors with multiple input ranges. With multiple input channels and

ranges, the channels can have different input ranges simultaneously, For example,

Channel 1 can be configured for a 200 mV input signal while Channel 8 can be

configured for 4-20 mA signal. These readings will be displayed on the screen and

uploaded to the software.

All calibrations are held in the EZ-DAQ and are password protected.

Sensor Input Type: mV, V, mA.

Sensor Input range: 150 mV, 500 mV, 1 V, 5 V, 10 V, 20 V, 4-20 mA

EZ-DAQ is configured for either SI or US customary units. At present, the internal

software does NOT allow the user to switch between the two units.

The EZ-DAQ-Soft™ software is user friendly, displaying all sensors on the PC screen.

The screen allows information from up to six sensors to be saved on 6 individual files

with 6 different sampling rates to be setup before the test begins. Files are saved as

delimited text which may be easily imported into a spread sheet program, or can be

opened as a simple text file.

Communication from the EZ-DAQ to the customers PC is accomplished using standard

Ethernet protocol with a USB to Ethernet adaptor. Setup is easy because it uses a static

IP address.

1 2 3 4 5 6 7 8 9 ... 24 25

Sem comentários

DGSI EZ-DAQ Manual do Utilizador Página 4